GPS & Navi
Showing all 20 results
-
-
Antennas, GPS & Navi, GPS/GSM Modems
Antenna GSM -2DBI Rubber Duck R/A SMA
Raspberry PIRaspberry Pi 3 – Model B Original with Onboard WiFi and Bluetooth
10 Days Returnable. Please refer to terms and conditions for summary
- Frequency Range MHz: Quad Band GSM
- Typical Gain dBi 2.0
- Input Impedance 50 ohm
- Polarization Type Vertical
- Connector Type Right Angle SMA Male
- Size D10.4x55mm
SKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
FPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsFPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
QUICK OVERVIEW
- Receiver type 72-channel Ublox M8 engine.
- Sensitivity Tracking & Nav: –167 dBm.
- Oscillator TCXO (NEO-M8N/Q).
- RTC crystal Built-In.
- Lowest noise figure (NEO-M8N/Q).
- Anti-jamming Active CW detection and removal. Extra.
- Onboard SAW bandpass filter (NEO-M8N/Q).
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
- Supported antennas Active and passive.
SKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
GPS/GLONASS GNSS Antenna for Raspberry Pi HAT and Arduino Shield with 3 Meter Cable
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsGPS/GLONASS GNSS Antenna for Raspberry Pi HAT and Arduino Shield with 3 Meter Cable
- The antenna assembly consists of a patch antenna for receiving GNSS signals and a preamplifier for signal amplification.
- Power supply to the antenna preamplifier must be provided by the application on the same RF signal trace as the GNSS RF signal is carried to the application.
- The antenna has an internal magnet so that it can be fixed on a metallic surface.
- Easy to use an antenna. Does not require RF or antenna knowledge.
This GPS/GLONASS GNSS Antenna is designed for applications which require high positioning accuracy by combining signals from GPS, GLONASS, systems. The tiny size of this antenna allows it to be used in very space restricted environments.
SKU: n/a -
-
-
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
OpenPilot CC3D EVO Flight Controller Straight Pin
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsOpenPilot CC3D EVO Flight Controller Straight Pin
- 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
- Tiny 36 x 36 mm 4 layer PCB for superior electrical noise reduction and flight performance.
- Software support for Windows, Mac, and Linux.
- Direct high-speed USB support with no drivers required, a true plug and play device.
- Spektrum satellite receiver support.
- Futaba S-BUS hardware support.
- Innovative Flexi-port technology for superior port flexibility.
- 4Mbits onboard EEPROM for configuration storage.
SKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
SIM808 Development GSM GPRS GPS Bluetooth SMS Module MINI SIM868 Board SIM868 Breakout Board 5V-18V
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsSIM808 Development GSM GPRS GPS Bluetooth SMS Module MINI SIM868 Board SIM868 Breakout Board 5V-18V
Horizontal Accuracy:<2.5m
Speed Accuracy(DGPS):0.05m/s
Acceleration Accuracy(DGPS):0.05m/s²
Timing Accuracy:10ns
Power Consumption:Acquisition:42mA (3.8V at -130dBm,GSM IDLE)Integrated AT Command Control
Fully Compliant with Bluetooth specification 3.0+EDR
Fully Integrated PA provide 10dbm output power
Max. support 4 way ACL linkSKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
SIM808 GSM/GPRS/GPS Bluetooth Compatible Development Board With GPS Antenna (Arduino and Raspberry Pi Compatible)
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsSIM808 GSM/GPRS/GPS Bluetooth Compatible Development Board With GPS Antenna (Arduino and Raspberry Pi Compatible)
- Quad-band 850/900/1800/1900MHz
- GPRS multi-slot class12 connectivity: max. 85.6kbps(down-load/up-load)
- GPRS mobile station class B
- Controlled by AT Command (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT Commands)
- Supports charging control for Li-Ion battery
- Supports Real Time Clock
- Supply voltage range 3.4V to 4.4V
- Integrated GPS/CNSS and supports A-GPS
- Supports 3.0V to 5.0V logic level
- Low power consumption, 1mA in sleep mode
- Supports GPS NMEA protocol
- Standard SIM Card
SKU: n/a -
Antennas, Arduino Boards, Arduino Shields, GPS & Navi, GPS/GSM Modems, IoT Boards
SmartElex GPS Data Logger Shield for Arduino
Quick ViewAntennas, Arduino Boards, Arduino Shields, GPS & Navi, GPS/GSM Modems, IoT BoardsSmartElex GPS Data Logger Shield for Arduino
- The multi-GNSS engine for GPS, GLONASS, Galileo, and QZSS.
- Embedded patch antenna.
- Automatic antenna switching function.
- High sensitivity: -167dBm @Tracking, -149dBm @Acquisition
- 99 acquisition channels, 33 tracking channels
- Balloon mode, for high altitude up to 80km
- Support DGPS, SBAS (WAAS/EGNOS/MSAS/GAGAN)
- Great anti-jamming performance due to multi-tone active interference canceller
- Support SDK command developed by Quectel
SKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
U-blox NEO-6M GPS Module with EPROM
- 5Hz position update rate.
- The cold start time of 38 s and Hot start time of 1 s.
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600).
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity.
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN).
- Separated 18 x 18mm GPS antenna.
SKU: n/a -
Antennas, GPS & Navi, GPS/GSM Modems, IoT Boards
Ublox NEO-M8N GPS Module with Compass for APM with extra connector for Pixhawk
Quick ViewAntennas, GPS & Navi, GPS/GSM Modems, IoT BoardsUblox NEO-M8N GPS Module with Compass for APM with extra connector for Pixhawk
- Dimensions: Outer diameter 54mm
- Weight 33gm
- Ready to Connect to All APM FC with 5-pin connector Attached
- Receiver type 72-channel Ublox M8 engine
- Galileo-ready E1B/C (NEO-M8N)
- Nav. update rate1 Single GNSS: up to 18 HZ
- Position accuracy 22.0 m CEP
- Acquisition2 Cold starts: 26 s
- Sensitivity2 Tracking & Nav: –167 dBm
- Onboard Compass
SKU: n/a