-17%
, , ,

FPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller


QUICK OVERVIEW

  1. Receiver type 72-channel Ublox M8 engine.
  2. Sensitivity Tracking & Nav: –167 dBm.
  3. Oscillator TCXO (NEO-M8N/Q).
  4. RTC crystal Built-In.
  5. Lowest noise figure (NEO-M8N/Q).
  6. Anti-jamming Active CW detection and removal. Extra.
  7. Onboard SAW bandpass filter (NEO-M8N/Q).
  8. Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
  9. Supported antennas Active and passive.

1,899.00 2,299.00

FPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller.  A new generation Ublox GPS NEO-M8N, with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy, support GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and mode or more.

Using 32-bit processor, compatible with NAZA M V1 & V2 flight controller, incomparably superior to 8-bit processor. Please take notice of the arrow on GPS, which stands for the head of a flyer. Similar calibration and usage with GPS. Coming with soft silicone gel cable 30cm. For softness, black rubber was wrapped on a surface. (Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok), Metal foil label has been mounted on the bottom of GPS to reduce signal interference from other electronic types of equipment

 Note: To calibrate the electronic compass is the first important thing when received your GPS.
 Calibration Method:
Connect GPS to Flight controller, dial the model switch of radio control 7-10 times, LED light turns orange; Turn the flyer horizontally one circle, then the LED light turns green; Make the head of a flyer downwards and turn it one circle, then the LED light flashed on.
GPS Chip parameters:
  • Receiver type 72-channel u-blox M8 engine
    GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
    SBAS L1 C/A: WAAS, EGNOS, MSAS
    Galileo-ready E1B/C (NEO-M8N)
    Nav. update rate1 Single GNSS: up to 18 HZ
    Concurrent GNSS: up to 10 Hz
    Position accuracy2 2.0 m CEP
    Acquisition2 Cold starts: 26 s
    Aided starts: 2 s
    Reacquisition: 1.5 s
    Sensitivity2 Tracking & Nav: –167 dBm
    Cold starts: –148 dBm
    Hot starts: –156 dBm
    Assistance AssistNow GNSS Online
    AssistNow GNSS Offline (up to 35 days)
    AssistNow Autonomous (up to 6 days)
    OMA SUPL & 3GPP compliant
    Oscillator TCXO (NEO-M8N/Q),
    Crystal (NEO-M8M)
    RTC crystal Built-In
    Noise figure On-chip LNA (NEO-M8M). Extra LNA for lowest noise figure (NEO-M8N/Q)
    Anti jamming Active CW detection and removal. Extra
    onboard SAW band pass filter (NEO-M8N/Q)
    Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N)
    Supported antennas Active and passive
    Odometer Travelled distance
    Data-logger For position, velocity, and time (NEO-M8N)
  • Operating temp. –40° C to 85° C
    Storage temp. –40° C to 85° C (NEO-M8N/Q)
    –40° C to 105° C (NEO-M8M)
    RoHS compliant (lead-free)
    Qualification according to ISO 16750
    Manufactured and fully tested in ISO/TS 16949 certified production sites
    Uses u-blox M8 chips qualified according to AEC-Q100
  • Supply voltage 1.65 V to 3.6 V (NEO-M8M)
    2.7 V to 3.6 V (NEO-M8N/Q)
    Power consumption4 23 mA @ 3.0 V (continuous)
    5 mA @ 3.0 V Power Save Mode (1 Hz, GPS mode only)
    Backup Supply 1.4 to 3.6 V
  • NEO-M8N-0 u-blox M8 Concurrent GNSS LCC Module,
    TCXO, flash, SAW, LNA,
    Timepulse Configurable 0.25 Hz to 10 MHz

 

Package includes:

– 1 x NEO-M8N GPS Module with APM Connector and extra PX4 connector.

Model FPV Ublox NEO-M8N
Receiver Type 72-channel Ublox M8 engine.
Main Chip Ublox NEO-M8N
Sensitivity Cold starts: –148 dBm.
Hot starts: –156 dBm.
Position Accuracy Autonomous: 2.5 m
SBAS: 2.0 m
Acceleration <4g
Navigation Update Rate up to 18 HZ.
Operating Temperature Range -24ºC ~ 84°C
pa_input-interface 36219
36218
36216
36217
Tracking Sensitivity –167 dBm.
Co-Ordinate System WGS-84
Capture Time 0.1s Average
Boot Time 1s Average
Dimensions (mm) LxWxH 50 x 12.8 (Dia x W)
Weight (gm) 28
Cable Length 30 CM
Supply Voltage (V) 1.4~3.6

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “FPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller”

There are no reviews yet.

X